GPIOGET(1) gpioget GPIOGET(1) NAME gpioget - libgpiod command-line utility SYNOPSIS gpioget [OPTIONS] ... DESCRIPTION Read values of GPIO lines. Lines are specified by name, or optionally by offset if the chip option is provided. OPTIONS -a, --as-is leave the line direction unchanged, not forced to input -b, --bias specify the line bias Possible values: 'pull-down', 'pull-up', 'disabled'. (default is to leave bias unchanged) --by-name treat lines as names even if they would parse as an offset -c, --chip restrict scope to a particular chip -C, --consumer consumer name applied to requested lines (default is 'gpioget') -h, --help display this help and exit -l, --active-low treat the line as active low -p, --hold-period wait between requesting the lines and reading the values --numeric display line values as '0' (inactive) or '1' (active) -s, --strict abort if requested line names are not unique --unquoted don't quote line names -v, --version output version information and exit Chips: A GPIO chip may be identified by number, name, or path. e.g. '0', 'gpiochip0', and '/dev/gpiochip0' all refer to the same chip. Periods: Periods are taken as milliseconds unless units are specified. e.g. 10us. Supported units are 'm', 's', 'ms', and 'us' for minutes, seconds, milliseconds and microseconds respectively. AUTHOR Bartosz Golaszewski REPORTING BUGS Report bugs to: Bartosz Golaszewski linux-gpio COPYRIGHT Copyright (C) 2017-2023 Bartosz Golaszewski License: GPL-2.0-or-later This is free software: you are free to change and redistribute it. There is NO WARRANTY, to the extent permitted by law. gpioget v2.3.1 (libgpiod v2.2.1) July 2026 GPIOGET(1)